Skip to main content

Skip to content

Home EV charging, explained

Plan home EV charging before you call an electrician

Work out what charging at home could cost from your own driving and electricity rate, compare Level 1 and Level 2, and check your panel, parking spot and permits before an electrician visits.

  • A charging cost estimator using your numbers
  • Level 1 and Level 2 compared plainly
  • A readiness checklist for panel and parking

Charging levels

Level 1 and Level 2 at home

Most home charging uses one of these two. Which fits depends on how far you drive, how long the car sits parked and what your electrical panel can carry.

At homeLevel 1Level 2
Power sourceA standard 120-volt household outletA 240-volt circuit, like the one an electric dryer uses
Charging speedA few miles of range per hourSeveral times faster, depending on the charger's amps and the car
EquipmentA portable cord, which some cars come withA wall-mounted or plug-in charger bought separately
Electrical workOften none, if a suitable outlet is near the carA dedicated circuit installed by a qualified electrician
PermitNot usually needed when no wiring changesOften required for the new circuit
Can suitShort daily drives, plug-in hybrids, long overnight parkingLonger commutes, bigger batteries, two EVs sharing a spot

Scroll the table sideways to see every column.

Charging speed also depends on the car's onboard charger, its battery level and the weather. Your car's manual lists its own Level 1 and Level 2 figures.

Cost worksheet

Work out a monthly charging cost

Enter how far you drive, your car's efficiency and your electricity rate. The worksheet turns miles into kWh, allows for charging losses and multiplies by the rate.

30 miles
30 days

Many cars show this in the dashboard or app. The example value is a placeholder.

90 percent

Some energy is lost as heat while charging. Level 1 tends to lose a little more than Level 2.

Use the all-in rate from your bill, or your off-peak rate if you charge overnight on a time-of-use plan.

Your charging figures

Energy drawn from the wall each month286 kWh
Monthly charging cost$43
Cost per mile4.8 cents

Arithmetic from the numbers you enter, not a quote or a price. It leaves out the charger, installation, taxes and any other charges on your bill.

Readiness checklist

Is your home ready for a Level 2 charger?

Work through these before an electrician visits, so the visit covers what matters. Ticks are not saved; print the list if you want to keep it.

0 of 18 done

Electrical panel
Parking spot and cable reach
Outdoor mounting
Permits, utility and Wi-Fi

This list helps you prepare. It does not replace an electrician's assessment or your local electrical code.

How installs go

How a home charger install usually goes

Every home and town is different, but most Level 2 installs follow a similar path.

  1. Know your car and your driving

    Note your daily miles, where the charge port is and the most power your car can accept on Level 2.

  2. Electrician visit

    A qualified electrician looks at the panel, works out the load and suggests a circuit size and charger location.

  3. Permit

    Where a permit is required, the electrician or the homeowner applies for it before work starts.

  4. Installation

    The electrician runs the circuit and mounts the charger or installs an outlet, with ground-fault protection where code calls for it.

  5. Inspection

    Where required, a local inspector checks the work before the charger goes into regular use.

  6. Set up and schedule

    Connect the charger's app if it has one, and schedule charging for off-peak hours if your rate rewards it.

Electrical work is a job for a qualified electrician

A Level 2 circuit connects to your home's main panel. Have a qualified electrician do the work, follow the charger maker's installation instructions, and ask your local building department whether a permit and inspection are required.

Questions

Common questions about charging at home

Can I charge an electric car from a regular wall outlet?

Yes. Most EVs can charge from a standard 120-volt outlet with a Level 1 cord. It adds only a few miles of range per hour, which can be enough for short daily drives when the car sits parked overnight. Car and charger makers generally advise against extension cords.

What size circuit does a Level 2 charger need?

It depends on the charger's amp rating and what your car can accept. EV charging counts as a continuous load, so the circuit is sized above the charger's draw; a charger drawing 32 amps typically goes on a 40-amp circuit. An electrician works this out for your panel and local code.

Do I need a permit to install a home EV charger?

Often, yes, when a new circuit is added for the charger. Rules differ by city and county, so ask your local building department. Many electricians handle the permit and arrange the inspection as part of the job; confirm who is responsible before work starts.

Can my electrical panel handle a Level 2 charger?

An electrician answers that with a load calculation, which weighs your home's existing loads against the panel's capacity. If there is not enough room, options can include a charger set to fewer amps, a load-management device that shares capacity, or a panel or service upgrade.

How does the AmpNest charging cost estimator work?

The AmpNest estimator divides your monthly miles by your car's miles per kWh, allows for charging losses using the efficiency you enter, and multiplies by your electricity rate. It is arithmetic from your own numbers, not a price; taxes, fees and time-of-use rules on your bill can change the result.

Can AmpNest book an electrician or install a charger?

No. AmpNest EV Charging is a design demo built by AltFTool, so its booking and install buttons are placeholders that send nothing. To have a charger installed, contact a qualified electrician you choose and ask about permits where you live.

Know your numbers before the electrician comes

Estimate the monthly cost from your own driving, then work through the readiness checklist so the site visit covers what matters.

About these demos

Home energy and utility page designs with fictional brands

AltFTool's Energy & Utilities demos are landing-page designs for home energy services, all with fictional brands: RateRidge for electricity plans, AmpNest for EV charging, SteadyCurrent for backup power, DraftSeal for energy audits, AquaLedger for water treatment and HearthFuel for propane and heating oil.

The calculators on these pages work from the numbers you enter, such as kilowatt-hours, miles driven or tank size, and none of them quotes a real rate. No brand sells energy or installs equipment, and electrical, gas and water decisions belong with your utility, a qualified installer and local codes.

Frequently asked questions

Are RateRidge, AmpNest and the other AltFTool energy brands real companies?

RateRidge, AmpNest, SteadyCurrent, DraftSeal, AquaLedger and HearthFuel are fictional brands made for AltFTool's energy page designs. None of them supplies electricity or fuel, installs chargers or generators, or tests water, and AltFTool sells none of these, so quote requests on these pages reach no company.

How does the EV charging cost calculator on AltFTool's AmpNest demo work?

The AmpNest calculator on AltFTool divides the miles you drive by your car's miles per kilowatt-hour, allows for charging losses and multiplies by the electricity rate you enter. The result is arithmetic from your own numbers, so check the rate you actually pay on your utility bill.

Who should install a home EV charger or a standby generator?

A home EV charger or standby generator is usually installed by a qualified electrician, often under a local permit, and a generator should feed home wiring only through a transfer switch. AltFTool's energy demos describe these steps in general terms and cannot assess any particular home.

What happens to the numbers typed into AltFTool's energy calculators?

Numbers typed into AltFTool's energy calculators are worked out in your browser and are not stored or sent anywhere. Only an email address entered in a sign-up box is saved, by AltFTool, which sends one email to confirm it, and you can unsubscribe from any message.

People also search for

  • electricity plan comparison website
  • ev charger installer website
  • generator installer landing page
  • home energy audit website
  • water treatment company website
  • propane delivery website design